Go the belt and road silk road

      
HOME ABOUT US PRODUCT NEWS NETWORK CONTACT

Corporate News

Welcome I plant selling graphite electrode models: RPHPUHP    EDi is willing to hold you the bridge of your success!

     
     
Product Series
RP Graphite Electrode
HP Graphite Electrode
UHP Graphite Electrode
Electrode Joint
Graphite Powder
Graphite Crucible

Instructions for use of Graphite Electrodes


Instructions for use of Graphite Electrodes

1, By the wet graphite electrode, before use to dry.
2, Remove the spare graphite electrode hole on the foam protective cap, check the electrode hole thread is complete.
3, With no oil and water compressed air cleaning spare graphite electrode surface and hole thread; to avoid the use of wire or metal brush cloth clean.
4. Do not touch the threads in the electrode holes where the joint is carefully screwed into one end of the spare graphite electrode (it is not recommended to insert the connector directly into the electrode that is replaced on the furnace).
5, The electrode spreader (recommended the use of graphite material spreader) screw into the other side of the electrode electrode electrode hole.
6, Lifting the electrode, the mat soft objects to the bottom of the alternate electrode assembly to prevent the ground to break the joints; with a hook into the spreader after the lifting ring, lifting the electrode to be smooth, to prevent the electrode from the B-loose Off or collide with other fixtures.
7, The spare electrode hanging to the top of the electrode to be connected to the electrode hole slowly after the fall; rotating the backup electrode, so that the screw hook and the electrode with the rotation down; in the two electrode end distance 10-20mm, again with compressed air Clean the two ends of the electrode and the exposed parts of the joint; in the final complete discharge of the electrode, not too much, or because of violent collision, will lead to electrode holes and joints of the thread damage.
8. Tighten the backup electrode with a torque wrench until the ends of the two electrodes are in close contact (the correct connection of the electrode and the connector is less than 0.05 mm).



Shanghai YiDi graphite Products - Graphite Electrode, Graphite Powder, Graphite Crucible Tel: 021-56531160 Address: Shanghai, China Office E-mailsh-edi@couplingsnet.com
CopyRight©2012 ALL rights teservde ICP NO. 14022750 -5 Website: www.couplingsnet.com All rights reserved Graphite Electrode Professional - Shanghai YiDi Precision Machinery Co., Ltd.

Links